I'm using the latest update of STAAD.Pro CONNECT Edition (22.03.00.28)When I try to run the model, this happens:
But when I check the output file, it is like this:
After assessing the output file, the number of errors shown after analysis reflects the number of these notes:
Note : Analytical Member ******Length = 166.566 is more than the length = 103.150 between DJ1 = 3 and DJ2 = 4
We tried to assign DJ1 and DJ2 to the beam start and end, consecutively, but nothing happened.Also tried to check what are these errors, but it turns out that the nodes mentioned/DJ1&DJ2 mentioned are not on the parameters itself.When we try to run it on a lower version (21.03.**.**), it works just fine (without error).
We just want to have an analysis with no errors shown.
Please help/assist.
Thanks.