I have created some shear wall in my job, up to modeling – there were no Errors, I can able to assign the surface property & able to view them clearly in the 3D rendered view of all the shear walls – as surface .
But, when I stepped in Analysis – I’m getting the above errors. What may be the grounds behind?
The part of the program as follows, is there any spots?
SET DIVISION 12
SURFACE INCIDENCE
7 15 91 83 SURFACE 1
83 91 167 159 SURFACE 2
159 167 243 235 SURFACE 3
235 243 319 311 SURFACE 4
311 319 395 387 SURFACE 5
Thanks & Regards
Thiru.
↧
